I have a very small but annoying dent above my rear fender. i would like to pull or push it out but would like to know if anybody on the forum has addressed a similar issue. I believe the aluminum is quite thick as I measured 3mm in a few spots using a micrometer. I'm not sure the 'painless dent' pulling is going to work here. However, getting to the backside of the body in that area is a real challenge. Before I move ahead, I'd like some advice. Thank you Scott

This is a sample of the piece. Udo has this in stock and says each car needs about 4.4 meters. It is a exact duplicate right down to the air hole in the tubing to make it more form fit. Thanks Udo for providing this. Check with Udo for pricing and shipping cost. U_BERNHARDT@gmx.de

Yes, I know. You'll never find them... But, if I can convince one of you who are blessed with an original set to get an impression or simple mold of the exterior shape of each side. I am happy to pay for the effort.